Special Features:

Bore length of shaft 0.750 in. Dia.; first end two internal threaded holes on 2.500 in. Bolt circle dia. 0.625 in. Dia. 1.125 in. Thd. Depth, drilled hole same bolt circle dia. Located 50 deg. From one thd. Hole center 135 deg. From other 0.250 in. Dia. Drilled at 30 deg. Angle through to bore; second end flat groove 2.625 in. Long located at end 0.938 in. Dia., drilled hole aong side flat groove 0.438 in. Deep

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.