Special Features:

Both ends chamfered 45 degrees by 0.030 in.; 0.189 in. Min to 0.190 in. Max diameter hole cut on axis of 1st end 1.200 in. Deep; largest step 0.849 in. Min to 0.854 in. Max; 2 oblong holes 0.225 in. Lg by 0.069 in. Min to 0.073 in. Max w/ends round cut through the largest step perpendicular to the shaft's axis, 0.432 in. From 1st end; 0.247 in. Min to 0.248 in. Max diameter groove 0.094 in. W cut 0.531 in. From 2nd end

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.