Special Features:

0.0525 in. Back from first end there is a flat cut at 60.0 degrees to 0.220 in. Dia; largest step has flat cut at 60.0 degrees to 0.344 in. Dia; hole 0.086 in. Dia; second end internal threaded hole 0.203 in. Dia; 10-32unf-2b thd; finish is e211 per mil-f-14072 and phosphated per specification k-f-1103; portions of shaft heat treated to rockwell c 45-57

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.