Special Features:

Second end has 0.300 inch counterbore 0.291 inch min., 0.321 inch max deep 0.940 inch from end. Shaft has a 45 degree bevel starting 2.620 inch from second end tapering to first end dia. Bevel has 0.125 inch dia. Hole drilled 0.500 inch down from start of bevel through to second end counterbore.

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.