Special Features:

One perpendicular drilled hole 0.328 in. Dia, 2.875 in. From end 0.750 in. Deep connecting w/longitudinal hole, longitudinal hole is thd 0.438 in. Deep 0.125-25 nptf w/90.0 degrees countersink by 0.438 in. Dia, end holes are countersunk 90.0 degrees by 0.500 in. Both sides

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.