Special Features:

Groove is included, 0.190 in. From the second end, 0.160 in.Wide; 4 holes, 0.190 in.Diameter; 2 centered longitudinal holes; first end, 3.060 in.In length, second end, 3.190 in.In length; 2 cross drilled holes, 1.440 in.Deep; first hole, 2.72 in.From first endsecond hole, 2.860 in.From second end; cross drilled holes intersect longitudinal holes

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.