Special Features:

Bore length of shaft with internal, involute spline, number of teeth 17, diametral pitch 48/96, pressure angle 30 degrees, minor diameter 0.3333 inch /0.3348 inch , major diameter 0.3832 inch /0.3903 inch ; internal ring forrve on both ends, distance from end to ring froove 0.268 inch /0.278 inch , ring groove width 0.029 inch /0.032 inch , ring groove diameter 0.395 inch /0.399 inch

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.