Special Features:

7larger end (1st): 0.998 inch diameter; 0.501 inch diameter x 1.000 inch deep blind hole; 0.127 wide keyway; first end also has 0.940 diameter x 0.047 inch wide groove; and 0.190 inch diameter chip hole. Smaller end (2nd): 0.625-11-nc-2a x 0.906 inch long threads then tapered square 0.844 inch long x 0.750 inch across flats, 0.750 inch per foot taper. Center of shaft has 1.375-3-2a left hand thread x 2.250 inch long; 1.375 inch largest shaft diameter; total four steps. Material is 303 stainless steel

Properties:

A drive shaft with external thread(s) and with machined bearing surface(s) and/or drive mechanisms other than a hub at one or both ends. The item mates with a cam, gear segment or lead nut and the like and may be used for actuating and power transmission purposes. Bearings may be included. Excludes gear rack and worm shaft. (replaces spindle, actuator, mechanical)