Model: 874261-5

Special Features:

Conversion coate per mil-c-5541, calss 1a. Item contains 8 .196 diameter holes. 1st hole located .5 from rt edge &1.60 from bottom; 4th hole located 2.917 to lt of 1st hole on same centerline; 3rd hole located 1.08 rt of 4th hole & .274 below centerline of 4th hole; 2nd hole located .750 to rt of 3rd hole on same centerline as 3rd hole; 5th hole located on same centerline as 1sthole & is 5.834 to lt of 1st hole; 6thhole located 2.998 to lt of 5th hole &.352 below centerline of 5th hole; 7thhole located 4.746 lt of 5th hole & .842 below centerline of 5th hole; 8th hole 0ocated 4.928 to lt of 5th hole & .784 above centerline of 5th hole

Properties:

A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes gasket; insulator (as modified) and mounting pad, electrical-electronic component.