Model: 874261-3

Special Features:

Conversion coat per mil-c-5541, class 1a. Item has 5 holes .196 dia; 1st hole located .50 in from rt end & 1.6 up from bottom; 2nd hole located on same center line & 2.97 to the left of1st hole; 3rd hole located 2.998 to left of 2nd hole & 1.352 below the center line of 2nd hole; 4th hole is located 4.746 left of 2nd hole & .842 below center line of 2nd hole; 5th hole located 4.928 to left of 2nd hole & .784 above center of 2nd hole.

Properties:

A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes gasket; insulator (as modified) and mounting pad, electrical-electronic component.