Special Features:

Drill hole 2.135 inches from left end .029 hole diameter at .342 inch deep. 2nd drill hole 6.780 from left end .039 hole diameter at .303 inch deep. .099 diameter hole .223 diameter x 90 degree csk nearside and farside 2 places, .156 and .750 from right end

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.