Special Features:

Material is stainless steel; this part of weapons handling athwartship drive gearbox sub assembly; protect this surface prior to assembly; angular relationship of spline 1 teeth may vary freely, as a unit, to spline 2 teeth; remove all burrs and sharp edges, and where machined corner or fillet radii are not dimensioned. .015 redius shall be used

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.