Special Features:

Hardened to rockwell c35-c38; 1stend is flanged, 0.600 in. Dia. By 0.060in. Thk.; 2nd end is beveled to 0.025 in. By 45 deg.; central groove is 0.350 in. Lg. And 0.2177 in. Deep; centralhole through entire lg. Of shaft, 0.3125 in. Dia. And countersunk to 0.030 in. By 90 deg. On 1st end; flange is cutaway to 0.127 in. Lg. By 0.080 in. Deep

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.