Special Features:

Nha, closure door assembly; shaft has third keyway 7.500 in from the first end and is 3.030 in long, keyways have radius ends and length does not include the radius; two 0.375-16unc-2b tapped holes drilled 0.500 in deep, firstis 10.500 in on center from second end, second is 11.500 in from second end, both are offset 65 degrees from center of keyway to center of hole; 45 degree x 0.12 chamfer both ends; full number 5 lathe centers both ends; item is tiodize type iv coated.

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.