Special Features:

First end bore drill (.236-243) to dim shown.Csink .300-320 diameter by 60 degrees incl angle-rm .262-268 diameter 1.670-1.700 dp-rm .279-283 diameter by 1.365-1.395 dp-conc w/.807 diameter w/in .010 f.I.R.; second end cir grooved 0.780 distance from end to groove, 0.500 groove w, 0.420 groove dia; second end optional ctr drill hole 0.110 dia; sec0nd end reqd int drill hole 0.093 dia, 0.250 distance btwn hole ctrs

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.