Special Features:

1 hole 0.188 in. Dia, 0.703 in. Deep located 2.450 in. From first end, 1 notch 30 degrees off center 0.500 in. W, 0.266 in. Deep, 0.250 in. From c to first end, 1 hole 0.469 in. Dia, 3.312 in. Lg

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.