Special Features:

Two notches 0.562 in. W, 0.203 in. Deep located on 2nd end 2.480 in. C to c distance between notches, 1.000 in. From center of 1st notch to end, one unthd crossed drilled hole located 6.322 in. From 2nd end, 0.250 in. Dia, 0.500 in. Deep with 30 degrees countersink 0.438 in. Dia

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.