Special Features:

1end chamfered 45 deg, depth 0.031, two drilled holes no. 18/0.168 in. Min 0.172 in. Max/on one side, no. 29/0.134 in. Min, 0.138 in. Max/on other side w/no. 8/0.164/32 nc 3bthd, holes, located 1.250 in. C to c on major dia, surface immunized, es-091

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.