Special Features:

2 holes each end, thru, perpendicclar, first holes 0.46 in. From ends, second holes 1.16 in. From end; 2 sections of shaft 1.76 from each end and 1.02 in. L. Machined to .450 in. Dia., filled with weld (haynes stellite no.6stellite 10300 welding rod) and ground back to .499 in. Dia.; .03x45 degree chamfer both ends

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.