Special Features:

Iem has a 0.060 slot in the 1st end only; from 1st end item is 0.587 in diameter for 0.717 then the diameter is 0.812 for 0.097, then diameter is 1.000 for 0.379, then diameter is 0.808 for 0.995, where the diameter becomes 0.66 for 0.22 max, then it has 0.75-16 unf-2a threads for 0.29, then the diameter is 0.559 for 0.883, then there is the 0.040 wide groove then after the groove the diameter is 0.587 to the end.

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.