Special Features:

One thd cross drilled hole 0.118 in. Dia, 0.250 in. Counterbore, 0.112-36 nc 2b, one on thd hole 0.117 in. Dia, 0.750 in. From center line of holes to end, thru slot on center line ofshaft @0.038 in. W, 0.969 in. Lg 0.750 in. From center line of slot to end

Properties:

A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.