Special Features:

Between 3shaft, outbd door link-v brace, upr, mlg; second step 1s located 3.30 inches from first end with a diameter of 1.4275 inches and 1.4290 and a length of 1.45 inches.The first and third and fifth step have a diameter of 1.370 inches and 1.380 inches . The first step is 3.30 inches long, the third step is 14.75 iinches long and the fifth step is 3.30inches long. The fourth step has a hole drilled through its center with the same dimension as the holes in steps one and five

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.