Special Features:

Two int thd holes 1.000 in. Lg, 1.500 in. Bolt cir diameter 1st end; 2nd end bored 1.630 in. Dia, 3.500 in. Deep, counterbored 1.741 in. Dia, 2.000 in. Dp, threaded near 2nd end 12 thds per inch

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.