Special Features:

Nha power takeoff transmission; end item cargo carrier 2350-01-456-7884; first end is quilled; heat treatment required: quench and temper to rockwell c32 through c36; shot peen entire part to an intensity of .007a to .014a per mil-s-13165 except areas designated; phosphate coat all surfaces per specification dod-p-16232, type m, class 2, waive abrasive blast requirements; using non-acid base white ink for marking

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.