Special Features:

The outside edge of the recessed side is chamfered, 0.03 in taper length by 45 degrees angle; used on xm1

Properties:

A washer of any peripheral shape having a centrally located hole. Both bearing surfaces are parallel and flat, but one or both of the bearing surfaces must be broken by a counterbore, countersink, or similarly shaped recess. The thickness must not exceed 25 per cent of the outside diameter or the largest outside dimension. The maximum limit of the tolerance or range applied to the thickness and/or largest outside dimension must be used to determine compliance. Excludes washer, concave, retainer, packing, and thrust type washers. See also spacer, sleeve; and spacer, stepped.