Special Features:

3 cross drilled holes, all holes 0.187 in. Min.-0.190 in. Max. Dia, first hole located 6.772 in. Lg. From center of hole to first end style, second hole located 5.347 in. Lg. From center of hole to first end style, third hole located 2.920 in. Lg. Fromcenter of hole to first end style

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.