Special Features:

First end has thd cross drilled through hole 0.160 in. Distance from hole c to end; first end bored 0.050 in. Diameter 0.240 in. Dp, counterbored 0.109 in. Diameter 0.090 in. Dp; first end has two cam lobes ea 0.070 in. W, ea cam lobe has a thd cross drilled through hole 0.300 in. Distance from thd hole c to end 0.135 in. Distance btwn thd hole c

Properties:

A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.